The home of high impact research in analytical, bioanalytical and detection science.
Subscribers
Non-subscribers
- Purchase article PDF [Ł27 + taxes]
- Purchase article PDF member offer [Ł5 + taxes]
Free access
Paper
Analyst, 2009, 134, 2306 - 2313, DOI: 10.1039/b910282e
Application of a nanoporous gold electrode for the sensitive detection of copper via mercury-free anodic stripping voltammetry
Jing-Fang Huang and Bo-Tsuen Lin
This paper describes how a new mercury-free alternative electrode material, nanoporous gold (NPG), was applied to improve the performance of detecting trace metals in stripping voltammetry. The NPG electrode was obtained by dealloying Zn from AuxZn1-x in a 40–60 mol% zinc chloride–1-ethyl-3-methylimidazolium chloride (ZnCl2–EMIC) ionic liquid. To prevent electrode fouling from surfactant adsorption, the short carbon-chain organothiol (3-mercaptopropyl)sulfonate (MPS) was selected to modify the NPG electrode through the formation of a self-assembled monolayer (SAM). The MPS-modified NPG (MPS@NPG) electrode not only significantly enhanced the sensitivity in detecting Cu2+ but also effectively prevented electrode surface fouling from surfactant adsorption. The electrode is easy to prepare and can be readily renewed after each stripping experiment. The dynamic range of calibration curve, y = 58.76x (in µA µM-1) + 3.90 (R2 = 0.999), showed very linear behavior with slope of 58.76 µA µM-1 (0.1–5 µg L-1). The detection limit is as low as 0.002 µg L-1 (0.031 nM). Non-ionic, anionic, and cationic surfactants were found to have no effect on Cu2+ detection when using the MPS@NPG electrode as a sensing probe. This method was applied to determining the Cu2+ in a reference material and three real water samples. The results agreed satisfactorily with the certified values.
RSS feed