Additions and corrections

Inkjet fabrication of polymer microarrays and grids—solving the evaporation problem

Albert Liberski, Rong Zhang and Mark Bradley

Chem. Commun., 2009, 334–336 (DOI: 10.1039/b816920a) Amendment published 22nd January 2009

There is an error in the paragraph beginning 'The thickness of the oil layer…' on page 334 column 2. The third sentence of this paragraph, which begins 'A 15 μm layer of oil…', should instead begin 'A 150 μm layer of oil…' The full sentence should read as follows:

A 150 μm layer of oil (density 0.89 g ml⁻¹) was optimal and using water drops (instead of monomers) it was found that there was no evaporation from the printed droplets even after 4 hours (see Fig. S1†).

There are also errors in Scheme 1. Where a thickness of 15 μm is indicated (two occurrences) this should read 150 μm. The correct graphic is shown below:

The Royal Society of Chemistry apologises for these errors and any consequent inconvenience to authors and readers.

Back to article